Page 1 of 1
If you prefer rubber top kegs...
Posted: Sat Jun 13, 2015 11:24 am
by alb
...as I do. I find them easier to lift.
$75 from Adventures in Homebrewing:
http://www.homebrewing.org/AIH-New-5-Ga ... _5100.html
Re: If you prefer rubber top kegs...
Posted: Sat Jun 13, 2015 11:48 am
by RickBeer
Alb ZERO is back! Long live Alb #0!
Re: If you prefer rubber top kegs...
Posted: Sat Jun 13, 2015 1:43 pm
by John Sand
Alb 0 sounds, well not great. I'm going with Alb Prime, or Original Alb.
Kind of wish I had bought the inexpensive new kegs instead of cheaper used ones. They're giving me a bit of trouble.
Re: If you prefer rubber top kegs...
Posted: Sat Jun 13, 2015 3:18 pm
by Gymrat
I like rubber top because I can stand them upside down to let water out after I wash them. But I can only fit 2 rubber top kegs in my kegorator where when I use the strap top I can get 3 kegs in it.
Re: If you prefer rubber top kegs...
Posted: Sat Jun 13, 2015 3:19 pm
by Gymrat
Oh and it is good to see the Original Alb back. Often imitated but never duplicated.
Re: If you prefer rubber top kegs...
Posted: Sun Jun 14, 2015 7:33 am
by Inkleg
John Sand wrote:Kind of wish I had bought the inexpensive new kegs instead of cheaper used ones. They're giving me a bit of trouble.
What trouble are they giving you? Start a thread in the kegging section, we'll see if we can help.
Re: If you prefer rubber top kegs...
Posted: Sun Jun 14, 2015 8:48 pm
by John Sand
I think I mentioned elsewhere (but maybe not on this forum) that I find them very difficult to dis-assemble. The tops have been glued back on previously, and the glue secured the posts as well. I managed to remove the out post on one, and cleaned the in post in place. But now it seems to have a slow leak. I'm still thinking about the whole thing, I'll start a thread if I get stumped.