BeerBorg

So I put an ESBish ale on tap a month ago. It's still murky and yeasty.
There may be a few culprits. My ferm fridge quit on brewday, I fermented a bit warmer than I would like. I also kegged sooner than usual. Generally I wait three weeks, this time a little less. The beer was still quite cloudy. That may have left more yeast in the keg. I'm not drinking it, just pulling an occasional pint to see if it is ready. My beers are usually very clear, but that doesn't matter as much to me as the yeast taste. Any ideas for treatment? Any experience with this? Thoughts on the cause?
Thanks.

It'll likely go away but even though it's clear, it might benefit from simply more conditioning. You could try some gelatin. Maybe that will drop more yeast out and help a bit.

Yep yep. My two best recommendations would be time and/or gelatin.

What yeast did you use? Warmer fermentation temp would mean faster fermentation, but not cloudy. With a correct yeast pitch and the low abv of an ESB it should have been at FG within a week with yeast dropping out and clear at week 2. Could you have transferred more yeast than normal when racking? Still at a month in the keg it should be pouring clear. Which brings me back to the first question.

US 05, which is why I call it "ESBish". I would have used Notty if my ferm fridge hadn't died. I used 05 because it can be decent above 70. I am confused by this, because I think it should be clear by now.