Here's where experience counts
Posted: Wed Dec 20, 2017 1:24 pm
So I've been brewing for what? Seven years now? Maybe eight, I don't know. I've gone from Mr. Beer HME kits to formulating my own AG recipes. So have most of you, I believe. 'Nuff sed on that, then. But here's what I experienced during this morning's brew session.
I decided to brew my White Panama Blonde Ale. A 2.5 gallon batch. I use BrewToad for my software, and I've added my recipes and printed them out for easy reference in a binder. Well, it seems I revised this recipe, adding a bit more malt, and while I revised it in BrewToad, I didn't print out the revision and replace the original in my binder. So my mash calculation was off a bit. I realized this when I saw that my mash resembled mortar more than what a proper mash-in should look like. I put the lid back on the tun to preserve the temperature and put some water in my pot and heated it up as quickly as I could. I didn't bother with measurements, I just eyeballed it and heated it, since time was a factor. So I got a nice mash out of it.
But I forgot to factor in that my calculations would also affect the sparge volume. Well, too late for remediation; after collection the sparge, I took a volume measurement and added another half gallon to the pre-boil.
As it turns out, I got exactly the post-boil volume I wanted, and hit the projected OG right on the nose.
Here's the lesson: Experience doesn't mean you're going to do it right every time. But it does mean that you can calmly and quickly recover from a mistake and have it turn out okay.
I decided to brew my White Panama Blonde Ale. A 2.5 gallon batch. I use BrewToad for my software, and I've added my recipes and printed them out for easy reference in a binder. Well, it seems I revised this recipe, adding a bit more malt, and while I revised it in BrewToad, I didn't print out the revision and replace the original in my binder. So my mash calculation was off a bit. I realized this when I saw that my mash resembled mortar more than what a proper mash-in should look like. I put the lid back on the tun to preserve the temperature and put some water in my pot and heated it up as quickly as I could. I didn't bother with measurements, I just eyeballed it and heated it, since time was a factor. So I got a nice mash out of it.
But I forgot to factor in that my calculations would also affect the sparge volume. Well, too late for remediation; after collection the sparge, I took a volume measurement and added another half gallon to the pre-boil.
As it turns out, I got exactly the post-boil volume I wanted, and hit the projected OG right on the nose.
Here's the lesson: Experience doesn't mean you're going to do it right every time. But it does mean that you can calmly and quickly recover from a mistake and have it turn out okay.