Twist on/off bottle capping

Vent, Rant, Chat or just talk about whatever is on your mind! Keep it civil though!

Moderators: BlackDuck, Beer-lord, LouieMacGoo, philm00x, gwcr

Post Reply
Pdunc
Newbie
Newbie
Posts: 14
Joined: Sat Aug 15, 2020 3:27 pm
Location: Maine

Twist on/off bottle capping

Post by Pdunc »

Watched Some YouTube videos that showed a number of people re-using glass bottles and twist off caps from commercial beers such as Blue Moon. They seemed to have had good success. What are the pros and cons to re-using twist off bottles and their caps? Also, I have one of those two hand cappers that I have never used. Any tips on using it properly on non twist off type bottles and regular crown caps which I purchased through Northwest?
bpgreen
Uber Brewer
Uber Brewer
Posts: 1983
Joined: Wed Aug 05, 2015 9:50 pm

Re: Twist on/off bottle capping

Post by bpgreen »

Pros of using a twist off bottle cap:
No need to use a capper.

Cons:
Bottles are typically thinner, especially at the neck.
It's difficult (although I've read that it's not impossible) to reattach the original cap.
If you plan to try to use a caapper, forget it. That's not going to work. If the neck doesn't break, the seal will likely be poor.


I should note that I've never actually tried it, but I never tried it becaue I read warnings similar to the above. Note that if you save the original cap, it may be possible to reuse it. I've read of *one* person who was able to do this successfully, but I've only been at this for a little more than 10 years.

If you have a capper, my advice is that you should buy some beer like Sierra Nevada, Sam Adams nu, etc (check for local brewries, too) that comes in a good sturdy bottle with a pry off cap. Reuse those bottles. You'll be much happier (and you'll be drinking better beer).
User avatar
The_Professor
Uber Brewer
Uber Brewer
Posts: 1018
Joined: Wed Aug 14, 2013 4:52 pm
Location: Calif, USA

Re: Twist on/off bottle capping

Post by The_Professor »

My understanding is that worst case scenario reusing twist off caps involves some small glass shards in the beer.
User avatar
John Sand
Brew Guru
Brew Guru
Posts: 4310
Joined: Wed Aug 07, 2013 9:01 pm
Location: Long Island NY

Re: Twist on/off bottle capping

Post by John Sand »

I have recapped twist off bottles a couple of times. I used a capper and new caps, it worked. This happened when some twist offs got mixed in with my pry off bottles. If I wanted to test the theory I would fill a dozen empties with water, cap them and turn them upside down for a couple of days. If they don't leak I would consider it a success. As for bottle strength, weight might be a good indicator. If you try it, please report your results.
Making beer and stew for the Zombie Apocalypse.
Never mind, there it is.
User avatar
berryman
Brew Guru
Brew Guru
Posts: 3280
Joined: Tue Aug 20, 2013 5:16 pm
Location: Western NY

Re: Twist on/off bottle capping

Post by berryman »

I have capped a few twist-off bottles a few times by accident with my bench capper and didn't break one and seemed to hold carb. I didn't try to twist them off because I didn't know I did it until opened them with a bottle opener. Personally I wouldn't do it intentionally. Let us know how it works, might be something we are missing.
Happy Hound Brewery

“I have not failed. I've just found 10,000 ways that won't work.”
― Thomas A. Edison
User avatar
Tabasco
Fully Fermented
Fully Fermented
Posts: 436
Joined: Sat Aug 10, 2013 9:45 am
Location: Long Island, NY

Re: Twist on/off bottle capping

Post by Tabasco »

:borg: I've never tried twiwstoff bottles, but always thought it was not possible to use them for bottling home brew. It was fun collecting the 600 or so empty sammies and other crafts, back in the 2010 Mr Beer days brrrrrpppppppp :jumpy:

I went from bottling to kegging a couple years later, and all those bottles are piled in storage bins in my brew room; I don't know what to do with them.
User avatar
John Sand
Brew Guru
Brew Guru
Posts: 4310
Joined: Wed Aug 07, 2013 9:01 pm
Location: Long Island NY

Re: Twist on/off bottle capping

Post by John Sand »

I gave most of mine away at homebrew meetings. I kept a case of 12s, and a case or so of swing tops. Sometimes I bottle to share.
Making beer and stew for the Zombie Apocalypse.
Never mind, there it is.
User avatar
FedoraDave
FedoraDave
FedoraDave
Posts: 4208
Joined: Fri Aug 09, 2013 5:52 pm
Location: North and west of the city
Contact:

Re: Twist on/off bottle capping

Post by FedoraDave »

It's my understanding (although I'm not sure how I came by this information) that twist-off bottles have thinner glass around the lip than pry-offs. This can lead to small bits of glass getting in the beer both at capping and uncapping.

It's also been said that a wing-capper won't seal them properly, but if you use a bench capper, it will work. YMMV.

If you want the convenience of twist-off bottles, I suggest you use PET bottles. Or any plastic soda bottles except for root beer, because they can hold the aroma and flavor of the soda and you can't ever wash it out.
Obey The Hat!

http://www.homebrew-with-the-hat.com

Some regard me as a Sensei of Brewing
Fedora Brauhaus
Up Next:
FedoraDave's American Ale
Fermenting/Conditioning
Natural 20 Pale Ale -- Bull Terrier Best Bitter -- King Duncan's Porter -- Schöenwald Schwarzbier -- Littlejohn's Ale
Drinking:
Crown Top Pale Ale
bpgreen
Uber Brewer
Uber Brewer
Posts: 1983
Joined: Wed Aug 05, 2015 9:50 pm

Re: Twist on/off bottle capping

Post by bpgreen »

FedoraDave wrote:It's my understanding (although I'm not sure how I came by this information) that twist-off bottles have thinner glass around the lip than pry-offs. This can lead to small bits of glass getting in the beer both at capping and uncapping.

It's also been said that a wing-capper won't seal them properly, but if you use a bench capper, it will work. YMMV.

If you want the convenience of twist-off bottles, I suggest you use PET bottles. Or any plastic soda bottles except for root beer, because they can hold the aroma and flavor of the soda and you can't ever wash it out.
Actually, you can successfully rid root beer bottles of the aroma and flavor. The key (I got this tip from yankeedag) is to rinse several times with cold washer as soon add it's empty, then use oxiclean free a few times. I think it also helps to pour the root beer into a glass so it's not sitting in the bottle for any length of time after the bottle is open.
User avatar
mashani
mashani
mashani
Posts: 6749
Joined: Sat Aug 10, 2013 11:57 pm

Re: Twist on/off bottle capping

Post by mashani »

I think one of the problems with wing cappers and twists offs is directly related to the thinner necks. My impression it that it is much easier to cause the little glass chips and/or even bust the necks off of bottles with a wing capper trying to cap them properly.
Pdunc
Newbie
Newbie
Posts: 14
Joined: Sat Aug 15, 2020 3:27 pm
Location: Maine

Re: Twist on/off bottle capping

Post by Pdunc »

I may have worded my original question incorrectly. What I was wondering was if anyone had success with twist off bottles using their original twist on caps. I do understand that because of the thin nature of the glass neck you would not want to cap one of those bottles with a pry off cap and capper. Trying to reuse a twist off bottle and it’s original twist on cap probably isn’t the best idea either, but having seen others on YouTube doing it, I was wondering if anyone on the forum has tried this. I still plan to continue using twist on caps on PET bottles and pry off caps on appropriate bottles.
User avatar
mashani
mashani
mashani
Posts: 6749
Joined: Sat Aug 10, 2013 11:57 pm

Re: Twist on/off bottle capping

Post by mashani »

My guess is it could work a few times per cap, if you twist it on to the right amount of torque and the cap was not deformed at all.
bpgreen
Uber Brewer
Uber Brewer
Posts: 1983
Joined: Wed Aug 05, 2015 9:50 pm

Re: Twist on/off bottle capping

Post by bpgreen »

Pdunc wrote:I may have worded my original question incorrectly. What I was wondering was if anyone had success with twist off bottles using their original twist on caps. I do understand that because of the thin nature of the glass neck you would not want to cap one of those bottles with a pry off cap and capper. Trying to reuse a twist off bottle and it’s original twist on cap probably isn’t the best idea either, but having seen others on YouTube doing it, I was wondering if anyone on the forum has tried this. I still plan to continue using twist on caps on PET bottles and pry off caps on appropriate bottles.
I've never tried it, but I vaguely remember reading of people who did that successfully,
Post Reply