Arrrg... Fighting with the liquid side of a new used keg

[BigPapaG]

And wishing I had one of these right now...

image.jpg (6.79 KiB) Viewed 685 times

Trying to recondition the keg before use...

Gonna have to either buy or make one to add to my ever expanding list of things..

[BigPapaG]

Whew... Got it off finally...

Was a lot tougher than the gas side although it looked just as bad...

Take a peek at the pic below... Think it needs a new washer?

The old one was just disintegrated on both... (New washer on the left for comparison)

image.jpg (137.93 KiB) Viewed 682 times

[Inkleg]

Yeah, that o-ring had seen better days.

[BigPapaG]

Yeah, that o-ring had seen better days.

Lol, yeah, like years ago!

Anyway, all new o-rings for dip tubes and connections... The lid o-ring was ok, as were the poppets so cleaned and sanitized everything and it's ready for a batch of cider!

Good example of why one should keep spare parts though...

[Inkleg]

Good example of why one should keep spare parts though...

McMaster Keg O-ring list is a good source. I still have plenty of 0-rings left.

[BigPapaG]

Good example of why one should keep spare parts though...

McMaster Keg O-ring list is a good source. I still have plenty of 0-rings left.

Cool beans...

I usually get them at my LHBS but might have to look into this...

Of course, I don't keep too many around...

Usually 2 lid rings, a half dozen connector rings and a half dozen dip tube rings, 2-4 poppets and an extra of each gas and liquid quick connects, two lengths of hose and a couple hose clamps. That's my repair kit basically...

EDIT: Oh yeah, and an extra picnic tap and one of those CO2 injector thingies with spare CO2 cartridges in case I run out of gas on a Sunday.

[GUI_Center]

You can buy cheap bulk o-rings on Amazon and if you have prime it's free shipping. I'm going to post all the links below. The dip tube o-rings are so cheap I change them out EVERY time so I never have to worry about any issues. Has not failed me yet.

Pack of 100 rubber dip tube o-rings. If you prefer silicone the can be had in a 100 pack here.

Pack of 25 silicone post o-rings. I don't change these until I need to so I bought 25 but the come in packs of 100 in both silicon and rubber.

And finally here is a pack of 10 rubber lid o-rings. If you prefer silicone they can be found here.